[srslte-users] New install, how to change LTE bandwidth?

[J Giovatto]

Hi
I had similar issue w n_prb=6.

Did you happen to see this warning in the enb logs ?

 TX SRB0 PDU size larger than MAC opportunity

If so you can try n_prb=15.

Joe


On 03/21/2018 09:46 AM, Patrick Cutno wrote:
>
> I have been using srsLTE 1.0 (before srsENB) was introduced and just
> made the switch to the current version. I looked through posts from
> the last few months but I couldn’t find clear instructions on what
> parameters to change in the configs to use different LTE bandwidths. I
> am trying to use 1.4 MHz.
>
>  
>
> In the eNb config I changed the “n_prb” to 6 but what do I do on the
> UE side? As is, the UE picks up the prb=6 and displays it in the trace
> but I immediately get a radio link failure. FYI, the default configs
> “out-of-the-box” work fine. So I can eliminate hardware as an issue.
>
>  
>
> What am I missing?
>
>
>
> _______________________________________________
> srslte-users mailing list
> srslte-users at lists.softwareradiosystems.com
> http://www.softwareradiosystems.com/mailman/listinfo/srslte-users


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.srsran.com/pipermail/srsran-users/attachments/20180321/87ba4c6c/attachment.htm>