[srslte-users] PLMN unknown

[Pedro Alvarez]

No, you do not need to recompile.
That is the point of a configuration file =)

On Mon, Sep 9, 2019 at 12:29 PM Saimanoj Katta <saimanoj.katta at cumucore.com>
wrote:

> Hi,
>
> Henry: Try passing the values from the command line for both EPC and eNB
> instead of changing the values in configuration file. This helped me at
> some point.
>
> Pedro: Do we need to rebuild/recompile the whole srsLTE, in case we change
> the parameters in configuration file and not pass the values via command
> line?
>
> Regards,
> Saimanoj
>
> On Mon, Sep 9, 2019 at 2:15 PM Pedro Alvarez <
> pedro.alvarez at softwareradiosystems.com> wrote:
>
>> Hi Henry,
>>
>> Just tested this myself without any issues.
>> Did you change the MCC and MNC in the EPC as well?
>>
>> Regards,
>> Pedro
>>
>> On Fri, Sep 6, 2019 at 11:40 AM Henry Rood <henry.rood at nerospec.com>
>> wrote:
>>
>>> Hi all
>>>
>>> I went thought the older threats but was unable to get something about
>>> PLMN unknown.
>>>
>>> I used 655 as MCC and 01 for MNC  the I get PLMN as 5698832
>>>
>>> Under sending S1 Setup Failure  - Unknown PLMN
>>>
>>> Any suggestions
>>>
>>>
>>>
>>> Henry ZS6IIX
>>>
>>>
>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> srslte-users mailing list
>>> srslte-users at lists.softwareradiosystems.com
>>> http://www.softwareradiosystems.com/mailman/listinfo/srslte-users
>>>
>> _______________________________________________
>> srslte-users mailing list
>> srslte-users at lists.softwareradiosystems.com
>> http://www.softwareradiosystems.com/mailman/listinfo/srslte-users
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.srsran.com/pipermail/srsran-users/attachments/20190909/9f3c5903/attachment.htm>